High-altitude truck maintenance contents frequently used on the construction site

The maintenance cycle of aerial work vehicles that often run on the construction site should be shortened and the components are easily damaged: tires, air conditioning filters, air filters, window glass, interior trim, paint, door seals, etc. should be checked and replaced frequently.

The high-altitude vehicles that often run on the construction site will have an increased chance of dusting inside the vehicle, especially at the age of high-altitude aerial vehicles. This is mainly due to the aging of the door seals. In this regard, you can take some do-it-yourself remedies. The owner of the aerial vehicle can go to the supermarket to buy a rubber protective agent and apply it to the sealing strip at the door. It is also possible to purchase a self-adhesive semi-circular door edge sealing strip to reinforce the adhesive tape on the side of the door. For other dusting The site should be checked and replaced at the maintenance site.

Every time it passes through the harsh environment of the site, it may also cause a large amount of dust in air-conditioning radiators and pipes. In particular, air-conditioning radiators of some aerial vehicles cannot be shared with engine radiators, so air-conditioning radiators must also be cleared in time. Dust in the pipeline, although it can not be directly contacted, but can be directly into the air intake air inlet dedicated cleaning agent, and then open the air conditioning loop, remove the dust in the pipeline. At the same time, for this type of aerial vehicle owners , it is necessary to often clean the air filter, the specific method is to open the hood, remove the Filter Element of the air conditioner filter, take the dust inside it to remove it, if it is found inside dirty, most Good replacement.

Welded Version Filter


SDRFL Welded series filter consists of a two-piece filter housing with a bolt-on cover plate. Inlet and outlet positioned at the opposite side and different position.

Connections for venting and draining and clogging indicator are all standard size. Filter elements of size 1320,2520,-15020 is twice times higher than size 1300, 2500-15000.

The dirt holding capacity and flow has increased greatly.

RFL W filter symbol


Filter Element

Filter elements are available with the following pressure stability values: BN/HC: 25 bar

P/HC: 10 bar

Wire mesh( W/HC ): 30 bar

V: 30 bar

General

Mounting: filter housing must be flexibly mounted and not fixed rigidly to the floor or used as a pipe support.

Temperature range -10℃~100℃

Pressure setting of clogging indicator

â–³Pa=2 bar-0.2 bar

Bypass cracking pressure

â–³Po=3 bar+0.5 bar

1 bar or 6 bar is available

RFL W mode code


RFL W filter dimension

RFL W filter dimension1

Truck Filter,Welded Version Filter,Hydrogen Welded Version Filter,Stainless Steel Welded Version Filter

Xinxiang Shengda Filtration Technique Co., Ltd. , https://www.filtrations.nl