The energy market is in tight supply The demand for energy-saving injection molding machines is increasing

Posted on

With the increasingly tense energy supply and high prices, the demand for energy-saving injection molding machines will increase, prompting many manufacturers to pay more attention to the development of energy-saving technologies. At present, based on the general injection molding machine, through the development and innovation, the technical content has been continuously improved. The energy-saving transformation of injection molding machines, as far as the current situation is concerned, is being shifted from the past flow ratio and pressure proportional control to variable control or quantitative control. Frequency conversion speed control, servo control injection molding machine, energy consumption than traditional equipment can be reduced by 30%. The proportion of the power consumption of the oil pump motor to the total power consumption of the equipment is as high as 50% to 65%, and therefore it is also extremely energy-saving. At present, the domestic injection molding machines generally use the combination of quantitative pumps, large and small pumps, variable pumps, and variable frequency technologies. The correct selection of oil pumps and motors can reduce resource waste. Designing and manufacturing a new generation of energy-saving injection molding machines has become a goal pursued by plastics machinery manufacturers. For example, Ningbo Haitian Group Co., Ltd. spends 5% of its sales each year on scientific and technological innovation research funding, and increases cooperation with universities and scientific research institutes such as Beijing University of Chemical Technology and Zhejiang University in high-speed, precision, energy saving, environmental protection, and other high-end There has been a breakthrough in performance. In another example, Zhenxiong Machinery (Ningbo) Co., Ltd. had sales of more than 300 million yuan last year, and sales of energy-saving injection molding machines accounted for about two-thirds of total sales, which was a year-on-year increase of more than 20%.

Terry Towel Warp Knitting Machine

Terry Towel Warp Knitting Machine is a highly-speed warp knitting machine, which running speed could up to 1,300RPM. Thanks to advanced technology and carbon fiber material widely used, warp knitting terry towel machine becomes more stable and higher productive compared with other terry machines.

A-ZEN TS4-C terry towel warp knitting machines, which also be called KS4FBZ, is equipped with Germany Needles, Carbon-fiber Needle bed and bars, laser-stops device as well as other market-tested spare parts, because of which A-ZEN terry towel machines gain a market acceptance since last 4 years.

Piles of warp knitting terry could reach to 6mm while back side of terry could be 3-4mm. The weight of warp knitting terry usually from 200-400gsm. Microfiber Polyester, Polyamaid and cotton yarn are available in warp knitting terry machine.


Technical Data:

Working Width/Gauge: 186"/ E24;

Working Speed: 50-1300rpm (Depends on yarn and designs);

Pattern Drive System: Pattern Disc or EL Drive (Optional);

Yarn Let-off Device: Electronical Yarn Let-off System;

Fabric Take-up: Electronical Fabric Take-up System;

Batching Device: Electronical Batching Device;

Laser Stops Detector;

Individual Terry Pile Brushing Device;

Online Service Supported.

Details please check machine leaflet.



Terry Towel Warp knitting machine,Terry machine,Microfiber towel machine

CHANGZHOU A-ZEN TEXTILE TECHNOLOGY CO.,LTD , https://www.barmachinery.com