The mold incubator is a "member" of the large family of incubators. It is mainly used to cultivate mold. By setting the corresponding temperature and humidity, the mold can grow out in about 4-6 hours. It can be used to artificially accelerate the propagation of mold. Inspecting the anti-mildew ability and degree of mildew of electrical and electronic products is an important detection method in the artificial three anti-climate.
Since it is used for cultivating molds, the sterilization of the incubator must be done regularly. According to Xiaotuo's time experience, if you have cultivated molds before and now want to cultivate other samples, you should sterilize them. The sterilization steps of the mold incubator mainly include: take a clean cloth and spray 75% alcohol, wipe the inner tank of the incubator, and then sterilize it with ultraviolet light; on this basis, if conditions permit, you can put it in the box. Point ozone, the sterilization effect is also very good. It is worth mentioning that most of the artificial climate incubators on the market now have a timing sterilization function. The user can set the sterilization time, automatically sterilize, and automatically turn off the sterilization function at the end of the sterilization time.
In addition, because most molds are suitable for growth at room temperature (25 degrees Celsius) and need to maintain a certain humidity when culturing on a solid substrate, the general mold incubator consists of a refrigeration system, a heating system, an air humidifier and a culture room. It is composed of control circuit and operation panel, and uses temperature sensor and humidity sensor to maintain the stability of the temperature and humidity in the cultivation room. Therefore, if we are performing sterilization or maintenance, we must be careful not to damage the sensor.
Since it is used for cultivating molds, the sterilization of the incubator must be done regularly. According to Xiaotuo's time experience, if you have cultivated molds before and now want to cultivate other samples, you should sterilize them. The sterilization steps of the mold incubator mainly include: take a clean cloth and spray 75% alcohol, wipe the inner tank of the incubator, and then sterilize it with ultraviolet light; on this basis, if conditions permit, you can put it in the box. Point ozone, the sterilization effect is also very good. It is worth mentioning that most of the artificial climate incubators on the market now have a timing sterilization function. The user can set the sterilization time, automatically sterilize, and automatically turn off the sterilization function at the end of the sterilization time.
In addition, because most molds are suitable for growth at room temperature (25 degrees Celsius) and need to maintain a certain humidity when culturing on a solid substrate, the general mold incubator consists of a refrigeration system, a heating system, an air humidifier and a culture room. It is composed of control circuit and operation panel, and uses temperature sensor and humidity sensor to maintain the stability of the temperature and humidity in the cultivation room. Therefore, if we are performing sterilization or maintenance, we must be careful not to damage the sensor.
Juice Cups,Plastic Juice Cup,Juice Cups With Lids,Portable Juice Cup
Zhongshan Lianwei Electrical Technology Co., Ltd. , https://www.zslwwaterpump.com